Junos Fusion Overview Junos Fusion is a technology running on Juniper platform which helps reduce network complexity and operational expenses by enabling multiple distributed devices to be managed as a single, logical device. In short, it combines multiple chassis hardware into single logical management. There are 3 different architectures of
It’s been a busy times and delayed for a while to share new blog post. Finally we are here, talking about how you can use ERPS for layer 2 ring protection on Juniper QFX. Introduction In case you do not know what ERPS is, it stands for Ethernet Ring Protection
Every network vendor always has their own procedure to perform password recovery. But you know what, you can add extra security layer to those procedure. Here are some reasons why you want to do that. Your network device might be installed in an unsecured location. The device configuration may contain
In this article, we are going to talk about QinQ tunneling configuration between Juniper MX10 and Cisco ASR1001, it’s basically Junos and IOS. Before going to the main part, let start with some introduction so that you understand a little bit about QinQ. Understanding QinQ Tunneling QinQ (formally defined as 802.1ad) is
Doing VPN is like creating a private path from one site to another so that you can transfer data between each other off the untrust network. In order to get VPN tunnel established, IP address of each end must be known. There should be three different cases for VPN setup.
Dynamic Multipoint VPN (DMVPN) is available for at least 10 years I can say. Also, there are many blog posts including Cisco about this topic, but because I am preparing for an exam, I am doing a lab about it then why not share it here for iNET9s’ readers. Introduction to
Few weeks back I have chance to configure IPSec VPN for one of our customers. It’s Juniper SRX at one side and Cisco IOS at another. Make sure you understand what VPN is then you are good to go with the example configuration below. The Sample Network Diagram Here is
SRX300 is a new series for Branch which has just been announced recently by Juniper Networks. It provides a good performance for Small and Medium Enterprise (SME). One of my customers has just purchased it and that’s why I have chance to play with it and share with you guys